| 经销商 | 联系方式 |
|---|---|
| 爱思创Extron电子 | 4000.398766、 021-3760 1568 |
Extron XTP R HDMI 是一款 XTP ® 接收器，可通过单根 CATx 屏蔽电缆在 100 m 远的距离上接收视频、音频、双向 RS-232 和红外及以太网信号。此接收器采用 HDMI 音频解嵌，带数字 S/PDIF 或模拟立体声音频输出。它也可通过以太网扩展、双向 RS-232 和红外插入功能来实现局域网接入和对远端视音频设备的控制。XTP R HDMI 接收器与 XTP Systems ® 配合使用，可用于远程终端之间的信号分配和长距离传输。
Extron XTP R HDMI 是一款 XTP
® 接收器，可通过单根 CATx 屏蔽电缆在 100 m 远的距离上接收视频、音频、双向 RS-232 和红外及以太网信号。此接收器采用 HDMI 音频解嵌，带数字 S/PDIF 或模拟立体声音频输出。它也可通过以太网扩展、双向 RS-232 和红外插入功能来实现局域网接入和对远端视音频设备的控制。XTP R HDMI 接收器与 XTP Systems
® 配合使用，可用于远程终端之间的信号分配和长距离传输。
特性
通过单根 CATx 屏蔽电缆在 100 m 远的距离上接收带嵌入音频的视频、双向 RS-232 和红外及以太网信号
支持分辨率高达 1920x1200 的计算机和视频信号，包括 1080p/60 深色和 2K
用于视音频设备控制的双向 RS-232 和红外插入
符合 HDCP 标准
支持远程供电
强烈建议使用 Extron XTP DTP 24 屏蔽双绞线电缆，以达到最佳的性能表现
EDID 管理器 (EDID Minder®) 自动地管理已连接设备之间的 EDID 通信
密钥管理器 (Key Minder ® ) 持续地验证 HDCP 标准，用于快速、可靠的切换
以太网扩展
HDMI 音频解嵌，带模拟立体声和数字 S/PDIF音频输出
音频输出音量调节和静音
可选择的 HDMI 音频直通
2 个继电器，用于控制房间功能
兼容所有的 XTP 产品
经 JITC 认证
示意图
面板图
| XTP R HDMI | |||
|
|||
|
|||
| Video | |||
|---|---|---|---|
| Gain | Unity | ||
| Resolution range | Up to 1920x1200*, 2K, or 1080p (HDTV) * reduced blanking |
||
| Signal type | Single-link HDMI (or DVI-D*) | ||
| Digital video | RGB digital video (DVI and HDMI standards) or Y, Cr, Cb digital component video (HDMI), actively buffered (supports all single-link DVI (if using an optional adapter) and HDMI standards from 640x480 @ 60 Hz to1920x1200 @ 60 Hz) | ||
| EDID and DDC | Supports Extended Display Identification Data (EDID) and Display Data Channel (DDC) data using DVI and HDMI standards. EDID and DDC signals are actively buffered. | ||
| HDCP | Compliant with High-bandwidth Digital Content Protection (HDCP) using DVI and HDMI standards | ||
| HPD | Supports hot plug detection (HPD) of display as a pass-through signal. | ||
| Maximum data rate | 6.75 Gbps (2.25 Gbps per color) | ||
| Maximum pixel clock | 165 MHz | ||
| Formats | RGB and YCbCr digital video | ||
| Standards | DVI 1.0, HDMI; HDCP 1.1 | ||
| Interconnection between transmitter and receiver | |||
| Connectors | 1 female RJ-45 per unit | ||
| Termination standards | TIA/EIA T568B | ||
| Signal transmission distance | 330' (100 m) using shielded twisted pair or XTP DTP 24 cable | ||
| Cable requirements | Solid conductor, 24 AWG or better | ||
| Cable recommendations | 400 MHz bandwidth, STP (Shielded Twisted Pair) | ||
|
|||
| Video output | |||
| Number/signal type | 1 single link HDMI (or DVI-D*) | ||
| Connectors | 1 female HDMI type A | ||
| Audio | |||
| Gain | Unbalanced output: 0 dB; balanced output: +6 dB | ||
| Frequency response | 20 Hz to 20 kHz, ±0.05 dB | ||
| THD + Noise | <0.1% @ 20 Hz - 20 kHz at nominal level | ||
| S/N | >90 dB, at maximum balanced output (unweighted) | ||
| Crosstalk | ≤-80 dB @ 1 kHz, fully loaded | ||
| Stereo channel separation | >80 dB @ 1 kHz | ||
| Sampling rates | 32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz | ||
| Bit depths | 16, 20, 24 bit | ||
| Audio output | |||
| Number/signal type | 1 analog stereo (2-channel), balanced/unbalanced 1 digital audio, embedded with HDMI output 1 digital audio via S/PDIF output connector |
||
| Connectors | (1) 3.5 mm captive screw connector, 5 pole 1 female HDMI type A (shared with video output) 1 female RCA jack |
||
| Supported formats | |||
| HDMI | LPCM up to 7.1/24-bit/192 kHz, Dolby TrueHD, Dolby Digital Plus, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel | ||
| S/PDIF | LPCM up to 7.1/24-bit/192 kHz, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-ES Discrete 6.1,DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel | ||
| Analog | Analog stereo audio | ||
| Impedance | |||
| Analog | 50 ohms unbalanced, 100 ohms balanced | ||
| Digital | 75 ohms (for S/PDIF output) | ||
| Maximum level (Hi-Z) | >+12 dBV balanced; +6 dBV unbalanced | ||
| Gain error | ±0.5 dB channel to channel | ||
| Volume control range | -100 dB to 0 dB (control 0 to 100 in 1 dB steps) | ||
|
|||
|
|||
| Communications — receiver | |||
| USB control ports | 1 front panel female mini USB B | ||
| USB standards | USB 2.0, low speed | ||
| Program control | Extron control/configuration program for Windows ® Extron Simple Instruction Set (SIS ™ ) |
||
| Communications — external device (pass-through, unidirectional or bidirectional) | |||
| Serial control port input/output | 1 set of proprietary signals on a female RJ-45 jack | ||
| Serial control port output/input | RS-232 (+5) via (1) 3.5 mm, 5-pole captive screw connector (uses 3 poles) (connector is shared with IR control port) | ||
| Baud rates | Up to 115200 baud | ||
| Protocol | Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none |
||
| Serial control pin configuration | 1 = Tx, 2 = Rx, 3 = Gnd | ||
| Ethernet pass-through port | 1 female RJ-45 connector | ||
| Ethernet data rate | 10/100Base-T, half/full duplex with autodetect | ||
| IR control port | (1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 40 kHz |
||
| IR control pin configuration | 3 = Gnd, 4 = IR Tx, 5 = IR Rx | ||
| Relay number/type | 2 normally open relays | ||
| Relay control connectors | (1) 3.5 mm captive screw connectors, 4 pole | ||
| Relay control contact rating | 24 V, 1 A | ||
| General | |||
| Power supply | External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1 A, 12 watts |
||
| Power consumption | |||
| Device | 8.9 watts, 12 VDC | ||
| Device and power supply | 10.8 watts, 12 VDC | ||
|
|||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
||
| Cooling | Convection, vents on sides and top | ||
| Thermal dissipation | |||
| Device | 29.9 BTU/hr | ||
| Device and power supply | 36.6 BTU/hr | ||
| Mounting | |||
| Rack mount | Yes, with optional 1U high rack shelf | ||
| Furniture mount | Yes, with optional under-desk mounting kit | ||
| Enclosure type | Metal | ||
| Enclosure dimensions | 1.0" H x 8.75" W x 6.0" D (half rack wide) (2.5 cm H x 22.2 cm W x 15.2 cm D) (Depth excludes connectors.) |
||
| Product weight | 1.6 lbs (0.7 kg) | ||
| Shipping weight | 4 lbs (2 kg) | ||
| Vibration | ISTA 1A in carton (International Safe Transit Association) | ||
| Regulatory compliance | |||
| Safety | CE, c-UL, UL UL rated for use in plenum airspaces: meets UL 2043 for heat and smoke release, excluding the power supply. |
||
| EMI/EMC | CE**, C-tick, FCC Class A**, ICES, KCC, VCCI | ||
| Environmental | Complies with the appropriate requirements of RoHS, WEEE. | ||
|
|||
| Product warranty | 3 years parts and labor | ||
| Everlast power supply warranty | 7 years parts and labor | ||
|
|||
|
|||
| (8.1-082114-D9) | |||
首页