爱思创Extron电子-产品详情-DAV音视工程网

经销商	联系方式
爱思创Extron电子	4000.398766、 021-3760 1568

　　MTP T SVA 45 可通过单根 CAT 5 类双绞线电缆将 S-视频和音频信号点对点传输至 300 m (1,000') 或更远的距离。它设计安装在通用的欧式 45 mm x 45 mm安装框架内，如墙盒、地插盒或电缆管道系统中，并提供 RAL9010 白色表面。.

相兼容的分配放大器
MTP DA4 和 MTP DA8	4 路和 8 路输出 MTP 双绞线分配放大器

可选附件
PS 124	多路输出 12 V 直流电源

　　MTP T SVA 45 可通过单根 CAT 5 类双绞线电缆将 S-视频和音频信号点对点传输至 300 m (1,000') 或更远的距离。它设计安装在通用的欧式 45 mm x 45 mm安装框架内，如墙盒、地插盒或电缆管道系统中，并提供 RAL9010 白色表面。.

　　MTP T SVA 45 通过 4 针 mini DIN 连接器接收 S-视频，通过 RCA 连接器接收音频。

　　所有的 MTP 发送器都是有源产品，能提供视频和音频的主动平衡传输。MTP T SVA 45 采用的 LED 电源指示灯可轻松进行故障诊断。

　　特性

　　通过单根 CAT 5 类电缆将视音频信号传输至 300 m (1,000') 或更远的距离

　　兼容 S-视频和立体声音频信号

　　设计安装在欧式墙盒、地插盒或电缆管道系统中

　　可选择双单声道音频或立体声音频输出功能

　　LED 电源指示灯

　　随附高度可靠的节能外置式通用电源，产品编号 #70-775-01

　　面板图

Panel Drawing

MTP AV Series Transmitters/Receivers

Video

Gain

Unity

Differential phase error

<1.0º at 3.58 MHz and 4.43 MHz

Differential gain error

<1.0% at 3.58 MHz and 4.43 MHz

Video input

Number/signal type

MTP T CV/AV Series

1 composite video

MTP T SV Series

1 S-video

MTP R CV/AV/SV Series

1 set of proprietary analog signals

Connectors

MTP T CV/AV Series

1 female BNC

MTP T AV AAP

1 female RCA

MTP T SV Series

1 female 4-pin mini DIN

MTP R CV/AV/SV Series

1 female RJ-45

Nominal level

1 Vp-p for Y of S-video and for composite video
0.3 Vp-p for C of S-video

Minimum/maximum levels

0.3 V to 1.5 Vp-p with no offset

Impedance

75 ohms

Return loss

<-30 dB @ 10 MHz

DC offset (max. allowable)

100 mV

Video output

Number/signal type

MTP T CV/AV/SV Series and MTP T AAP Series

1 set of proprietary analog signals

MTP R CV/AV Series

1 composite video

MTP R SV Series

1 S-video

Connectors

MTP T CV/AV/SV Series

1 female RJ‑45

MTP T AAP Series

1 female RJ‑45 on a 3" (7.6 cm) pigtail

MTP R CV/AV Series

1 female BNC

MTP R SV Series

(1) 4-pin mini DIN

Nominal level

1 V p-p for Y of S-video and for composite video
0.3 V p-p for C of S-video

Minimum/maximum levels

0.3 V to 1.5 Vp-p

Impedance

75 ohms

Return loss

<-35 dB @ 5 MHz

DC offset

±20 mV with input at 0 offset

Sync

Standards

NTSC 3.58, NTSC 4.43, PAL, SECAM

Audio — audio models (A, AV, SVA models) only

Gain

RCA models

Unbalanced output: 0 dB (unity)

All other models

Unbalanced output: 0 dB (unity); balanced output: +6 dB

Frequency response

20 Hz to 20 kHz, ±0.25 dB

THD + Noise

0.03% @ 1 kHz, 0.3% @ 20 kHz at nominal level

S/N

RCA models

>90 dB, at maximum output (unweighted)

All other models w/audio

>90 dB, balanced at maximum output (unweighted)

Crosstalk

<-80 dB @ 1 kHz, fully loaded

Stereo channel separation

>75 dB @ 1 kHz

CMRR

>34 dB @ 20 Hz to 20 kHz

Audio input — audio models (A, AV, SVA models) only

Number/signal type

MTP T AV, MTP T SV A

1 stereo, balanced/unbalanced

MTP T AV/SV A RCA, MTP T AAP

1 stereo, unbalanced

MTP R Series

1 set of proprietary analog signals

Connectors

MTP T AV, MTP T SV A

(1) 3.5 mm captive screw connector, 5 pole

MTP T AV/SV A RCA, MTP T AAP

1 pair of RCA female

MTP R Series

1 female RJ‑45 (shielded)

Impedance

>5.6k ohms ±5% unbalanced, >10k ohms ±5% balanced

Nominal level

-10 dBV (0.32 Vrms)

Maximum level

>+2.4 dBu (balanced or unbalanced) at 1%THD+N

NOTE

0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu.

Audio output — audio models (A, AV, SVA models) only

Number/signal type

MTP T Series (all models)

1 set of proprietary analog signals

MTP R AV, MTP R SV A

1 stereo or dual mono, balanced/unbalanced

MTP R AV/SV A RCA

1 stereo or dual mono, unbalanced

Connectors

MTP T Series

1 female RJ‑45 (shielded)

MTP T AAP Series

1 female RJ‑45 on a 3" (7.6 cm) pigtail

MTP R AV, MTP R SV A

(1) 3.5 mm captive screw connector, 5 pole

MTP R AV/SV A RCA

1 pair of RCA female

Impedance

MTP R AV, MTP R SV A

50 ohms unbalanced, 100 ohms balanced

MTP R AV/SV A RCA

50 ohms unbalanced

Gain error

±0.1 dB channel to channel

Maximum level (Hi-Z)

>+3.3 dBu, balanced or unbalanced at 1%THD+N

Maximum level (600 ohm)

>+2.0 dBm, balanced or unbalanced at 1%THD+N

General

External power supply

100 VAC to 240 VAC, 50/60 Hz, external; to 12 VDC, 2.0 A, regulated

Power input requirements

12 VDC, 0.2 A (max.) with no load; 0.45 A (max.) with full load

NOTE

If the distance between the transmitter and receiver is less than 500' (150 m) and if the internal jumper is in setting 2, you can connect a power supply to only one device in a transmitter/receiver pair. If the distance between transmitter and receiver is greater than 500' (150 m) or if the internal jumper is in setting 1 (default), connect a power supply to each device.

Temperature/humidity

Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing

Cooling

Convection, unvented

Rack mount

MTP T AAP Series

Yes, with optional rack panel, or furniture-/wall-mountable with optional AAP mounting plates

All other models

Yes, with optional 1U, 9.5" deep rack shelf, part #60-190-01 or 60-604-01; or VersaTools® 1U, 3" deep rack shelf, part #60-190-20 or 60-604-20. Also furniture-mountable with optional brackets.

Enclosure type

Metal

Enclosure dimensions

(Depths exclude connectors and cables.)

MTP T AAP Series

Faceplate

1.4" H x 3.5" W x 0.1" D (3.6 cm H x 8.9 cm W x 0.3 cm D) (double space AAP plate)

Transmitter

1.35" H x 2.7" W x 1.3" D (3.4 cm H x 6.9 cm W x 3.3 cm D)

All other models

1.7" H x 2.2" W x 3.0" D (1U high, one-eighth rack wide)
4.2 cm H x 5.6 cm W x 7.6 cm D

Product weight

1.0 lbs (0.5 kg)

Shipping weight

3 lbs (2 kg)

Vibration

ISTA 1A in carton (International Safe Transit Association)

Listings

UL, CUL

Compliances

CE, FCC Class A, VCCI, AS/NZS, ICES

MTBF

30,000 hours

Warranty

3 years parts and labor

NOTE

All nominal levels are at ±10%.

NOTE

Specifications are subject to change without notice.

(7.52-101907-D17)

可选附件
PS 124	多路输出 12 V 直流电源

暂无相关下载!!!