| 经销商 | 联系方式 |
|---|---|
| 爱思创Extron电子 | 4000.398766、 021-3760 1568 |
Extron MTP 15HD RS 系列是多用途双绞线发送器和接收器系列，用于在单根双绞线电缆上长距离传输高分辨率计算机视频和 RS-232 信号。所有型号均兼容高达 1920x1200 WUXGA 的分辨率，支持的 XGA 信号电缆传输距离可达 600'（185 m）或更远，UXGA 信号可达 450'（135 m）或更远。
Extron MTP 15HD RS 系列是多用途双绞线发送器和接收器系列，用于在单根双绞线电缆上长距离传输高分辨率计算机视频和 RS-232 信号。所有型号均兼容高达 1920x1200 WUXGA 的分辨率，支持的 XGA 信号电缆传输距离可达 600'（185 m）或更远，UXGA 信号可达 450'（135 m）或更远。
延长距离接收器
对于需要将信号传输至更远距离的视音频系统，MTP 1500RL 15HD RS 和 MTP 1500RL 15HD RS SEQ 两种型号的接收器可以通过单根 CAT 5 类电缆接收传输距离达 1500'（450 m）或更远的高分辨率视频以及传输距离达 1000'（300 m）的 RS-232 信号。
特性
通过单根 CAT 5 类电缆传输高分辨率视频和 RS-232 信号
传输距离为 600'（185 m）和 1500'（450 m）的不同接收器型号
兼容分辨率高达 1920x1200 的视频信号
适用于不同安装环境的多种产品规格
支持 RGBHV、RGBS、RGsB、RsGsBs、分量视频、S-视频和复合视频
与 HDTV 分量视频兼容，双电平或三电平同步
随附外置式通用电源，产品编号为 70-775-01
输入：带缓冲环通的 RJ-45 插座
输出：15 针 HD 插座用于视频，螺丝锁定器用于 RS-232
独立可变电平和峰值控制
缓冲 MTP 输出，用于对多达 8 个接收器进行菊花链式连接
可对每种色彩进行独立的扭曲延时补偿调整
可机架安装的 1U 高、1/4 机架宽的磨砂金属外壳
示意图
面板图
| MTP 15HD RS Series | |||
| Video | |||
|---|---|---|---|
| Gain | Unity | ||
| Number/signal type | |||
| MTP 4T 15HD RS | 4 sets of proprietary analog signals | ||
| All other models | 1 set of proprietary analog signals | ||
| Connectors | |||
| MTP 4T 15HD RS | 4 female RJ-45 | ||
| MTP R 15HD RSA D | 1 female RJ-45 on a pigtail | ||
| All other models | 1 female RJ-45 | ||
| Video input and loop-through — transmitter (MTP T 15HD RS, MTP C7 T 15HD RS, MTP 4T 15HD RS) | |||
| Number/signal type | 1 analog RGBHV, RGBS, RGsB, RsGsBs, component video (with bi-level or tri-level sync), S-video, or composite video 1 buffered RGBHV, RGBS, RGsB, RsGsBs local monitor loop through (includes ID bits) |
||
| Connectors | 2 female 15-pin HD | ||
| Nominal level | 1 Vp-p for Y of component video and S-video, and for composite video 0.7 Vp-p for RGB and for R-Y and B-Y of component video 0.3 Vp-p for C of S-video |
||
| Minimum/maximum levels | 0.3 V to 1.45 Vp-p | ||
| Impedance | 75 ohms | ||
| Horizontal frequency | 15 kHz to 130 kHz | ||
| Vertical frequency | 30 Hz to 150 Hz | ||
| Return loss | <-30 dB @ 5 MHz | ||
| DC offset (max. allowable) | 250 mV | ||
| Video output — receivers | |||
| Number/signal type | |||
| MTP R 15HD RSA D | 1 analog VGA-UXGA RGBHV, RGBS, RGsB, RsGsBs, HD component video, component video, S-video, or composite video | ||
| All other receivers | 1 set of proprietary analog signals 1 analog RGBHV, RGBS, RGsB, RsGsBs, component video (bi-/tri-level sync), S-video, or composite video |
||
| Connectors | |||
| MTP R 15HD RSA D | 1 female 15-pin HD | ||
| All other receivers | 1 female RJ-45 1 female 15-pin HD |
||
| Nominal level | 1 Vp-p for Y of component video and S-video, and for composite video 0.7 Vp-p for RGB and for R-Y and B-Y of component video 0.3 Vp-p for C of S-video |
||
| Minimum/maximum levels | 0.3 V to 1.45 Vp-p | ||
| Impedance | 75 ohms | ||
| Return loss | <-30 dB @ 5 MHz | ||
| DC offset | <±20 mV with input at 0 offset | ||
| Skew compensation | 62 ns | ||
| Maximum resolution | |||
| MTP 1500RL 15HD RS SEQ | Up to 1600x1200 and 1080p at 1500' Up to 1920x1200 and 2048x1080 at 1200' |
||
| All other models | Up to 1920x1200 or 2048x1080 or 1080p at 300' Up to 1024x768 at 600' |
||
|
|||
| Sync | |||
| Input type (transmitter) | RGBHV, RGBS, RGsB, RsGsBs | ||
| Output type (receivers) | RGBHV, RGBS, RGsB, RsGsBs | ||
| Standards | NTSC 3.58, NTSC 4.43, PAL, SECAM | ||
| Input level (transmitter) | 3.5 V to 5.5 Vp-p, unterminated | ||
| Output level (receivers) | |||
| MTP 1500RL 15HD RS SEQ | 0.3 Vp-p for component video (bi-level sync) 0.6 Vp-p for component video (tri-level sync) TTL: 4.0 V to 5.0 V p-p, unterminated for RGBHV, RGBS |
||
| All other models | 4.0 V to 5.0 Vp-p, unterminated | ||
| Input impedance | |||
| MTP C7 models | 573 ohms | ||
| All other models | 510 ohms | ||
| Output impedance | |||
| MTP C7 models | 92 ohms ±8% (25 mA) | ||
| All other models | 110 ohms | ||
| Polarity | |||
| Transmitter | Positive or negative (follows input polarity) | ||
| Receivers | Positive or negative (switch selectable) | ||
| Control/remote — external device (pass-through, unidirectional or bidirectional) | |||
| Serial control port input/output | |||
| MTP T 15HD RS, MTP C7 T 15HD RS, MTP 4T 15HD RS | RS-232 via (1) 3.5 mm, 3 pole captive screw connector | ||
| MTP R 15HD RSA D, MTP C7 RL 15HD RS, MTP C7 RL 15HD RS SEQ | 1 set of proprietary signals on a female RJ-45 jack | ||
| Serial control port output/input | |||
| MTP T 15HD RS, MTP C7 T 15HD RS, MTP 4T 15HD RS | 1 set of proprietary signals on a female RJ-45 jack | ||
| MTP R 15HD RSA D | RS-232 via 3 poles of a 3.5 mm captive screw connector, 5 pole | ||
| All other receivers | RS-232 via a 3.5 mm, 3 pole captive screw connector | ||
| Baud rates | |||
| MTP R 15HD RSA D, MTP 1500RL 15HD RS SEQ | Up to 38400 bps at up to 1000' (304.8 m) | ||
| All other models | Up to 38400 bps at up to 600' (183 m) | ||
|
|||
| Protocol | Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none |
||
|
|||
| Serial control pin configuration | Captive screw connectors: 1 = Tx, 2 = Rx, 3 = GND | ||
| General | |||
| Recommended cable type | |||
| Models other than C7 models | CAT 5/5e/6 (shielded or unshielded) | ||
| Required cable type | |||
| MTP C7 15HD models | Extron STP201 or CAT 7 | ||
| Power supply | |||
| MTP 4T 15HD RS | Internal Input: 100-240 VAC, 50-60 Hz |
||
| All other models | External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1 A, 12 watts |
||
| Power input requirements | For models except MTP 4T 15HD RS | ||
| MTP 1500RL 15HD RS SEQ | 12 VDC, 1.0 A max. | ||
| All other models | 12 VDC, 0.5 A | ||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
||
| Cooling | |||
| MTP 1500RL 15HD RS SEQ | Convection, vents sides to top | ||
| All other models | Convection, no vents | ||
| Mounting | |||
| Rack mount | |||
| MTP R 15HD RSA D | No | ||
| MTP 4T 15HD RS | Yes, with included mounting kit | ||
| All other models | Yes, with optional 1U rack shelf | ||
| Furniture mount | |||
| MTP R 15HD RSA D | Yes, using a standard electrical wall box or decorator-style size mud ring | ||
| MTP 1500RL 15HD RS SEQ | No | ||
| All other models except MTP 4T 15HD RS | Yes, with optional mini under-desk mounting kit | ||
| Wall mount | |||
| MTP 1500RL 15HD RS SEQ | Yes, with optional wall mounting kit | ||
| Pole mount | |||
| MTP R 15HD RSA D | No | ||
| MTP 1500RL 15HD RS SEQ | No | ||
| All other models except MTP 4T 15HD RS | Yes, with optional pole mounting kit | ||
| Enclosure type | Metal | ||
| Enclosure dimensions | |||
| MTP R 15HD RSA D | |||
| Faceplate | 2.6" H* x 1.3" W x 0.24" D (6.6 cm H* x 3.3 cm W x 0.5 cm D) *Overall height is 4.1" (10.4 cm) including mounting tabs. (Fits the opening in a 1 gang, 4.4" H x 2.7" W decorator-style wallplate. Depth excludes connectors.) |
||
| Device | 2.75" H x 1.65" W x 1.3" D (7.0 cm H x 4.2 cm W x3.3 cm D) (Depth excludes connectors.) |
||
| MTP 4T 15HD RS | 1.7" H x 17.5" W x 8.5" D (1U high, full rack wide) (4.3 cm H x 44.4 cm W x 21.6 cm D) (Depth excludes connectors.) |
||
| MTP 1500RL 15HD RS SEQ | 1.0" H x 8.75" W x 6.0" D (half rack wide) (2.5 cm H x22.2 cm W x15.2 cm D) (Depth excludes connectors.) |
||
| All other models | 1.7" H x 4.3" W x 3.0" D (1U high, quarter rack wide) (4.3 cm H x 10.9 cm W x 7.6 cm D) (Depth excludes connectors.) |
||
| Product weight | |||
| MTP 4T 15HD RS | 6.0 lbs (2.7 kg) | ||
| MTP 1500RL 15HD RS SEQ | 1 lb (0.5 kg) | ||
| All other models | 0.4 lbs (0.2 kg) | ||
| Vibration | ISTA 1A in carton (International Safe Transit Association) | ||
| Regulatory compliance | |||
| Safety | CE, c-UL, UL | ||
| EMI/EMC | CE, C-tick, FCC Class A, ICES, VCCI | ||
| Warranty | 3 years parts and labor | ||
|
|||
|
|||
| (CMS-041917-D11) | |||
首页