Extron CTR8 可为 Extron 大部分带 RS-232 控制的单功能切换器或图像解析度转换切换器，或 Extron IP Link 控制处理器增加触点闭合控制功能。CTR8 可接受多达 8 路触点闭合输入并将其转换为简单指令集 (SIS™)，从而对 Extron 切换器进行输入选择，或通过 Extron IP Link 控制处理器来控制 CTR 8 的各路输入信号。通过开关切换功能即可实现视频的显示或不显示，方便用户对演示内容进行控制。每个触点闭合输入采用一路 +5 V 电源输出，为当前输入信号的 LED 指示灯供电。为了简化安装，+12VDC 的电源环通端口还允许与另一个 Extron 产品共用外置电源。在需要通过触点闭合对 Extron 切换器或控制处理器进行控制的应用环境，CTR8 无疑是理想之选。
| 快速参考 |
|---|
| Everlast 电源 (宣传册) |
| TeamWork - CTR 8 (宣传册) |
| 随附附件 | ||
|---|---|---|
| MBU 123 | 用于 1/8、1/4 和 1/2 机架宽产品的薄型安装套件 | 70-212-01 |
| 可选附件 | ||
|---|---|---|
| ZipClip 200 | 用于 1/8 和 1/4 机架宽产品的安装套件 | |
| ZipClip 100 | 用于 PS 系列电源的安装套件 | |
| 安装故事 |
|---|
| Extron XTP Systems and Pro Series Control Bring Advanced AV to Historic Auditorium The Ca' Foscari University of Venice was established in 1868 as the first business school in Italy, and became a premier State University in 1935. Today, approximately 20,000 students are enrolled in degreed programs covering multiple disciplines of science, humanities, economics, foreign languages, and literature... |
Extron CTR8 可为 Extron 大部分带 RS-232 控制的单功能切换器或图像解析度转换切换器，或 Extron IP Link 控制处理器增加触点闭合控制功能。CTR8 可接受多达 8 路触点闭合输入并将其转换为简单指令集 (SIS™)，从而对 Extron 切换器进行输入选择，或通过 Extron IP Link 控制处理器来控制 CTR 8 的各路输入信号。通过开关切换功能即可实现视频的显示或不显示，方便用户对演示内容进行控制。每个触点闭合输入采用一路 +5 V 电源输出，为当前输入信号的 LED 指示灯供电。为了简化安装，+12VDC 的电源环通端口还允许与另一个 Extron 产品共用外置电源。在需要通过触点闭合对 Extron 切换器或控制处理器进行控制的应用环境，CTR8 无疑是理想之选。
特性
为 Extron 大部分带 RS-232 控制的单功能切换器或图像解析度转换切换器增加触点闭合控制功能
将触点闭合输入转换为Extron SIS 串行指令集
+5 VDC 输出为外部 LED 供电
可选择 LED 显示模式的视频屏蔽控制
+12 VDC 环通电源端口
兼容 TeamWork Show Me 电缆
1U 高、1/4 机架宽金属外壳
随附外置 Extron Everlast™ 电源, 产品编号 #70-1174-01 — 该全球通用型电源具有经验证的高可靠性和低功耗，能够降低运行成本
Extron Everlast 电源可享受 7 年部件及人工保修
示意图
TeamWork Application
TeamWork Room System
Button Panel Control
Custom TeamWork Collaboration System using wired Show Me Cables and Scaling Presentation Switcher. Visit the TeamWork System Builder to create a custom TeamWork configuration.
Custom TeamWork Collaboration System using wired Show Me Cables and Scaling Presentation Matrix Switcher. Contact your Extron Representative for assistance creating this Teamwork configuration.
DSC 301 HD System Design
面板图
| CTR 8 | |||
| Control — host port | |||
|---|---|---|---|
| Serial control port | 1 bidirectional RS-232 on a 3.5 mm captive screw connector, 3 pole | ||
| Baud rate and protocol | 9600 baud, 8 data bits, 1 stop bit, no parity | ||
| Serial control pin configuration | Pin 1 = Tx, pin 2 = Rx, pin 3 = Gnd | ||
| Program control | Extron Simple Instruction Set (SIS ™ ) | ||
| Control — unidirectional serial port | |||
| Switcher control port | (1) 3.5 mm captive screw connector,3pole for unidirectional RS-232 control (±5 V) | ||
| Baud rate and protocol (RS-232) | 9600 (default), 19200, 38400, 57600 baud; 8 data bits; 1stop bit; no parity | ||
| Pin configuration | Pin 1 = not used, pin 2 = Tx, pin 3 = Gnd | ||
| Control — contact closure inputs with tally | |||
| Number/signal type | 8 contact closure inputs and 8 tally outputs | ||
| Connector | (8) 3.5 mm captive screw connector, 4 pole | ||
| Contact closure and tally pin configurations | C = contact, G = ground, T = tally, +V = +5 V (200 mA max) 200 mA max is shared between all +V pins. |
||
| General | |||
| Power supply | External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1.0 A, 12 watts |
||
| Power input requirements | 12 VDC, 0.25 A (no load on Power Out connector) 12 VDC, 1.0 A max (load on Power Out connector) |
||
| Power consumption | |||
| Device | 2.9 watts, 12 VDC (no load on Power Out connector) 12.4 watts, 12 VDC (full load on Power Out connector) |
||
| Device and power supply | 3.8 watts, 100-240 VAC, 50-60 Hz (no load on Power Out connector) 15.2 watts, 100-240 VAC, 50-60 Hz (full load on Power Out connector) |
||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
||
| Cooling | Convection, no vents | ||
| Thermal dissipation | |||
| Device | 4.9 BTU/hr (no load on Power Out connector) 37.3 BTU/hr (full load on Power Out connector) |
||
| Device and power supply | 8.0 BTU/hr (no load on Power Out connector) 46.8 BTU/hr (full load on Power Out connector) |
||
| Mounting | |||
| Rack mount | Yes, with optional 1U rack shelf | ||
| Furniture mount | Yes, with included MBU 123 | ||
| Pole mount | Yes, with optional mini pole mount | ||
| Enclosure dimensions | |||
| Device | 1.7" H x 4.3" W x 3.0" D (1U high, quarter rack wide) (4.3 cm H x 10.9 cm W x 7.6 cm D) (Depth excludes connectors.) |
||
| Product weight | 0.7 lbs (0.3 kg) | ||
| Shipping weight | 2.0 lbs (1.0 kg) | ||
| Vibration | ISTA 1A in carton (International Safe Transit Association) | ||
| Regulatory compliance | |||
| Safety | CE, c-UL, UL | ||
| EMI/EMC | CE, C-tick, ICES, FCC Class A, VCCI, ICES | ||
| Environmental | Complies with appropriate requirements for RoHS and WEEE | ||
| Product warranty | 3 years parts and labor | ||
| Everlast power supply warranty | 7 years parts and labor | ||
|
|||
|
|||
| (8.0-121713-D1) | |||
| 可选附件 | ||
|---|---|---|
| ZipClip 200 | 用于 1/8 和 1/4 机架宽产品的安装套件 | |
| ZipClip 100 | 用于 PS 系列电源的安装套件 | |
首页