| 经销商 | 联系方式 |
|---|---|
| 爱思创Extron电子 | 4000.398766、 021-3760 1568 |
MLCPlus100 是一款易用的以太网控制器，设计用于处理常用的视音频功能，如视音频设备的电源开/关、输入切换、音量调节和以太网控制等。其面板能够将安装螺丝隐藏起来，再加上圆角和坡口式设计，使控制器呈现出雅致、时尚的外观。MLC Plus 100采用 6 个可定制及可配置的按键，并具有一个用于 Extron MPA 系列和部分 XTRA™ 系列放大器的远程音量控制端口。以太网供电 (PoE) 功能允许 MLCPlus100 通过单根以太网电缆获取电源及进行通信。它安装在两单元接线盒中，并随附黑色和白色面板。
| 快速参考 |
|---|
| MediaLink Plus 系列 (宣传册) |
| 可选附件 | ||
|---|---|---|
| XTP PI 100 | 用于 XTP 和 Pro 系列控制系统的电源合路器 | |
| EWB 系列 | 外置式墙面接线盒 | |
| 红外发射器和屏蔽套件 | 用于 Extron 带红外输出产品的红外发射器套件 | |
| 兼容的软件 | ||
|---|---|---|
| Global Configurator Plus 和 Global Configurator Professional | 用于视音频控制系统的强大配置软件 | |
| Extron Control | 用于 TouchLink、eBUS、网络按键面板和 MediaLink 的控制应用程序 | |
MLCPlus100 是一款易用的以太网控制器，设计用于处理常用的视音频功能，如视音频设备的电源开/关、输入切换、音量调节和以太网控制等。其面板能够将安装螺丝隐藏起来，再加上圆角和坡口式设计，使控制器呈现出雅致、时尚的外观。MLC Plus 100采用 6 个可定制及可配置的按键，并具有一个用于 Extron MPA 系列和部分 XTRA™ 系列放大器的远程音量控制端口。以太网供电 (PoE) 功能允许 MLCPlus100 通过单根以太网电缆获取电源及进行通信。它安装在两单元接线盒中，并随附黑色和白色面板。
特性
通过标准以太网络管理、监视和控制视音频设备
通过 Global Configurator Plus 或 Global Configurator Professional 进行完全的配置
2 个双向 RS-232 端口
2 个继电器，用于控制房间功能
1 个红外端口，最多可连接两个发射器
1 路数字输入
用于 Extron MPA 系列和部分 XTRA™ 系列放大器的远程音量控制端口
以太网供电功能允许控制器通过单根以太网电缆获取电源及进行通信，无需本地电源
支持以太网可控设备
使用 GC Plus 多达 4 个设备
使用 GC Pro 多达 8 个设备
双色、可现场贴标签的背光按键
示意图
MLC PLUS 100
面板图
| MLC Plus 100 | |||
| Memory | |||
|---|---|---|---|
| SDRAM | 512 MB | ||
| Flash | 512 MB | ||
| Software and control options | |||
| Software | Extron Global Configurator Plus and Professional for Windows ® | ||
| Control options | GlobalViewer ® Extron Control for Web, Extron Control for iPad ® | ||
| Ethernet control | |||
| Network interface controllers (NICs) | 1 | ||
| Connector | 1 female RJ-45 connector | ||
| Data rate | 10/100/1000Base-T, half/full duplex with autodetect | ||
| Protocols | DHCP, DNS, HTTP, HTTPS, ICMP, NTP, SFTP, SMTP, SNMP, SSH, TCP/IP, UDP/IP | ||
| Default settings | Link speed and duplex level = autodetected IP address = 192.168.254.250 Subnet mask = 255.255.255.0 Gateway = 0.0.0.0 DHCP = off DNS: 127.0.0.1 |
||
| Serial control | |||
| Quantity/type | 2 bidirectional RS-232 | ||
| Connectors | (2) 3.5 mm captive screw connectors, 3 pole | ||
| Baud rate and protocol | 300 to 115200 baud (9600 baud = default); 8 (default) or 7 data bits; 1 (default) or 2 stop bits; no parity (default), even, odd, mark, or space parity |
||
|
|||
| Pin configurations | |||
| Serial, 3-pole captive screw | Pin 1 = Tx, 2 = Rx, 3 = Gnd | ||
| Digital input control | |||
| Quantity/type | 1 digital input | ||
| Connectors | (1) 3.5 mm captive screw connector, 2 pole | ||
| Digital input | |||
| Input voltage range | 0 to 24 VDC, clamped at +30 VDC | ||
| Input impedance | 17.5k ohms | ||
| Programmable pullup | 1k ohms to +5 VDC | ||
| Threshold low to high | >2.8 VDC | ||
| Threshold high to low | <2.0 VDC | ||
| Pin configurations | 1 = digital input, 2 = Gnd | ||
| IR control | |||
| Quantity/type | 1 TTL level (0 to 5 V) infrared (carrier and non-carrier) up to 300 kHz | ||
| Connectors | (1) 3.5 mm captive screw connector, 2-pole | ||
| Pin configurations | Pin 1 = signal, 2 = Gnd | ||
| IR output carrier frequency | 30 kHz to 300 kHz | ||
| Relay control | |||
| Quantity/type | 2 normally open relays | ||
| Relay control connectors | (1) 3.5 mm captive screw connector, 3 pole | ||
| Relay control contact rating | 24 VDC, 1 A | ||
| Volume control | |||
| Quantity/type | 1 volume control (compatible with select Extron amplifiers) | ||
| Connectors | (1) 3.5 mm captive screw connector, 3 pole | ||
| Pin configuration | Pin 1 = ≤10 VDC reference voltage input, pin 2 = 0 to +10 VDC control voltage output, pin 3 = Gnd | ||
| Control voltage output range | 0 to +10 VDC (±0.2 volts), adjustable | ||
| General | |||
| Power supply | Not included | ||
| Power input requirements | 12 VDC, 1 A, 12 watts, max. Or power over Ethernet (PoE) (complies with PoE 802.3af, class 3) |
||
| Power consumption | |||
| Device | 2.2 watts, 12 VDC 3.7 watts, 48 VDC (PoE) |
||
| Device and power supply | 3.0 watts, 100-240 VAC, 50-60 Hz | ||
| Device and PoE injector | 5.0 watts, 100-240 VAC, 50-60 Hz | ||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
||
| Cooling | Convection, no vents | ||
| Thermal dissipation | |||
| Device | 7.3 BTU/hr (using 12 VDC) 12.6 BTU/hr (using 48 VDC, PoE) |
||
| Device and power supply | 10.0 BTU/hr | ||
| Device and PoE injector | 17.1 BTU/hr | ||
| Mounting | |||
| Rack mount | No | ||
| Furniture or wall mount | Yes, in a standard US 2-gang electrical junction box or mud ring | ||
| Enclosure type | Plastic faceplate and high-impact plastic rear enclosure | ||
| Enclosure dimensions | |||
| Faceplate | 4.5" H x 4.6" W x 0.3" D (11.4 cm H x 11.7 cm W x 0.8 cm D) | ||
| Device | 2.7" H* x 3.5" W x 2.2" D (6.9 cm H* x 8.9 cm W x 5.5 cm D) (Depth excludes faceplate and buttons. Fits most 2 gang US boxes or mud rings. Allow at least 2.4" [6.1 cm] depth in the wall or furniture.) |
||
 |
|||
| Product weight | 0.8 lb (0.4 kg) | ||
| Shipping weight | 2 lbs (1 kg) | ||
| Vibration | ISTA 1A in carton (International Safe Transit Association) | ||
| Regulatory compliance | |||
| Safety | CE, c-UL, UL | ||
| EMI/EMC | CE, C-tick, FCC Class A, ICES, VCCI class A | ||
| Environmental | Complies with the appropriate requirements of RoHS, WEEE | ||
| Accessibility | Complies with the appropriate requirements of Section 508 of the Rehabilitation Act (29U.S.C.794d). | ||
| Product warranty | 3 years parts and labor | ||
|
|||
|
|||
| (8.1-061215-D2) | |||
| 可选附件 | ||
|---|---|---|
| XTP PI 100 | 用于 XTP 和 Pro 系列控制系统的电源合路器 | |
| EWB 系列 | 外置式墙面接线盒 | |
| 红外发射器和屏蔽套件 | 用于 Extron 带红外输出产品的红外发射器套件 | |
首页