爱思创Extron电子-产品详情-DAV音视工程网

经销商	联系方式
爱思创Extron电子	4000.398766、 021-3760 1568

　　Extron HDMI 201 A D 是一组 decorator 型发送器和接收器，可以传输 HDMI 或 DVI 信号，并且传输距离大大超过标准 HDMI 或 DVI 电缆的距离限制。此外，它可以接受和传输立体声音频及 RS-232 或红外信号。与两根经济且方便集成的 CATx 或 Extron STP201 电缆相连接，HDMI 201 A D 发送器和接收器配合使用时可以将 HDTV 和 XGA 1024x768 分辨率的 HDMI 或单链路 DVI 信号传输超过 60 m (200') 远的距离。

　　特性

　　通过 CATx 电缆传输 HDMI 和控制信号

　　使用 CATx 屏蔽电缆可将 720p、1080i 和 XGA 1024x768 信号传输超过 60 m (200' )，将 1080p/60 和 1920x1200 信号传输超过 30 m (100') 100'（30 m）的距离

　　Extron 强烈建议使用独立的屏蔽双绞线电缆，以达到最佳的性能表现

　　Extron STP201 数字双绞线电缆可针对外界干扰提供额外保护，从而增加了信号传输的总体距离

　　符合 HDCP 标准

　　传输额外的立体声音频信号

　　双向 RS-232/红外直通

　　为发送器和接收器远程供电

　　示意图

Product Diagram

　　面板图

Panel Drawing

HDMI 201 A D Tx/Rx

NOTE	This product consists of a transmitter (HDMI 201 AD Tx) and a receiver (HDMI 201 A D Rx) with twisted pair cables linking the transmitter and receiver.

NOTE	*Appropriate HDMI to DVI-D cables or adapters are required for DVI signal input/output.

Video

Maximum data rate

4.95 Gbps (1.65 Gbps per color)

Maximum pixel clock

165 MHz

Resolution range

Up to 1920x1200 or 1080p @ 60 Hz

Formats

RGB and YCbCr digital video

Standards

DVI 1.0, HDMI

Video input — Tx units

Number/signal type

1 single link HDMI (or DVI-D*)

Connectors

1 female HDMI type A

Interconnection between transmitter and receiver

Connectors

2 femaleRJ-45 per unit for 2 cables connecting the transmitter and receiver

Termination standards

TIA/EIA T568A or T568B

Signal transmission distance

1920x1200 or 1080p @ 60 Hz

Extron STP201 cable

Up to 150' (45 m)

CAT 5/5e/6 STP

Up to 125' (38 m)

CAT 5/5e/6 UTP

Up to 100' (30 m)

720p/1080i or 1024x768 @ 60 Hz

CAT 5/5e/6 UTP or STP or Extron STP201

200' (60 m)

NOTE	The transmission distance varies greatly depending on the signal resolution and on the type of cable, graphics card, and display used in the system.

NOTE	Shielded twisted pair cable provides added protection from outside interference and increases overall signal transmission distance. Extron strongly recommends using shielded twisted pair for optimal performance.

Video output — Rx units

Number/signal type

1 single link HDMI (or DVI-D*)

Connectors

1 female HDMI type A

Audio

Gain

Unbalanced output: 0 dB; balanced output: +6 dB

Frequency response

20 Hz to 20 kHz, ±0.06 dB

THD + Noise

0.18% @ 1 kHz at nominal level

S/N

>76 dB at maximum output (unweighted)

Stereo channel separation

>63 dB @ 1 kHz

Audio input

Number/signal type

HDMI 201 A D Tx

1 stereo, unbalanced

HDMI 201 A D Rx

1 stereo, balanced/unbalanced

Connectors

HDMI 201 A D Tx

1 pair female RCA jacks (tip, ring)

HDMI 201 A D Rx

(1) 3.5 mm captive screw connector, 5 pole

Impedance

HDMI 201 A D Tx

>10k ohms unbalanced, DC coupled

HDMI 201 A D Rx

>18k ohms unbalanced, 24k ohms balanced, DC coupled

Nominal level

HDMI 201 A D Tx

-10 dBV (316 mVrms)

HDMI 201 A D Rx

+4 dBu (1.23 Vrms)

Maximum level

HDMI 201 A D Tx

+6.3 dBu, unbalanced at 1% THD+N

HDMI 201 A D Rx

+16.6 dBu, unbalanced at 1% THD+N

NOTE	0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu

Audio output

Number/signal type

HDMI 201 A D Tx

1 stereo, balanced/unbalanced

HDMI 201 A D Rx

1 stereo, unbalanced

Connectors

HDMI 201 A D Tx

(1) 3.5 mm captive screw connector, 5 pole

HDMI 201 A D Rx

1 pair female RCA jacks (tip, ring)

Impedance

HDMI 201 A D Tx

50 ohms unbalanced, 100 ohms balanced

HDMI 201 A D Rx

50 ohms unbalanced

Maximum level (Hi-Z)

HDMI 201 A D Tx

>11.4 dBu, balanced or unbalanced at 1% THD+N

HDMI 201 A D Rx

>5.3 dBu, unbalanced at 1% THD+N

Maximum level (600 ohm)

HDMI 201 A D Tx

>5.1 dBm, balanced or unbalanced at 1% THD+N

HDMI 201 A D Rx

>4.7 dBm, unbalanced at 1% THD+N
>+9 dBm, balanced or unbalanced at 1% THD+N

Control/remote — external device (pass-through)

Serial control port input

Transmitter

RS-232 via (1) 3.5 mm, 3 pole captive screw connector

Receiver

1 set of proprietary signals on a female RJ-45 jack

Serial control port output

Transmitter

1 set of proprietary signals on a female RJ-45 jack

Receiver

RS-232 via a 3.5 mm, 3 pole captive screw connector

NOTE	Protocol is mirrored between the transmitter and the receiver.

Serial control pin configuration

Captive screw connectors: 1 = Tx, 2 = Rx, 3 = GND

General

Power supply

External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 watts

Power consumption

HDMI 201 A D Tx

3.0 watts, 12 VDC

HDMI 201 A D Rx

4.0 watts, 12 VDC

NOTE	Each transmitter or receiver can be powered either locally by an external power supply or remotely by receiver or transmitter on the other end of the CAT 5/5e/6 or ExtronSTP201 cables.

Temperature/humidity

Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing

Cooling

Convection, no vents

Mounting

Furniture mount

Wall or furniture mountable in a decorator-style opening

Enclosure type

Metal

Enclosure dimensions

Faceplate

2.6" H* x 1.3" W x 0.1" D (6.6 cm H* x 3.3 cm W x 0.3 cm D)
(Fits the opening in a 1 gang decorator-style wallplate.)
*Overall height is 4.1" (10.4 cm) including mounting tabs.

Device

2.7" H x 1.8" W x 1.25" D
(6.9 cm H x 4.6 cm W x 3.2 cm D)
(Height excludes mounting tabs, depth excludes connectors.)

Product weight

0.5 lbs (0.3 kg)

Vibration

ISTA 1A in carton (International Safe Transit Association)

Regulatory compliance

Safety

CE, c-UL, UL

EMI/EMC

CE**, C-tick, FCC Class A**, ICES, VCCI

NOTE	**CE and FCC testing is conducted with STP (shielded twisted pair) cable.

Warranty

3 years parts and labor

NOTE	All nominal levels are at ±10%.

NOTE	Specifications are subject to change without notice.

(CMS-041317-D18)

暂无相关附件!!!

暂无相关下载!!!