返回
爱思创电子（上海）有限公司_爱思创Extron中国
-MTP T 15HD RS图片
-MTP T 15HD RS
厂家报价：价格面议
生产状态：在产
爱思创Extron电子
爱思创Extron电子
详情
爱思创电子（上海）有限公司（爱思创Extron中国）全球总部位于美国加州，是世界领先的专业视音频系统集成产品的生产商。爱思创Extron产品主要包括视音频控制系统、计算机视频接口、切换器、矩阵切换器、...
经销商 联系方式
爱思创Extron电子 4000.398766、 021-3760 1568
  • 产品
  • 参数
  • 附件配件
  • 下载

　　Extron MTP 15HD RS 系列产品中包括通用的微型双绞线发送器和接收器，用来通过一根非屏蔽双绞线电缆将高分辨率计算机视频和RS-232 串行控制信号远距离发送到演示显示设备.

　　它们与分辨率高达 1600 x 1200 的信号兼容，可分别将XGA 信号和UXGA 信号发送到185 米和135 米以外。

特性

　·输入：用于视频输入的 15 针 HD 插座和用于 RS-232 输入的螺丝锁定器

　·输出：用于非屏蔽双绞线的 RJ-45 插座

　·峰值预调电路用于优化视频信号的远距离传送质量

　·本地监视器缓冲输出

　·通过一根CAT 5、5e 或 6 的非屏蔽双绞线电缆发送和接收高分辨率视频信号和双向RS-232 信号到185 米以外

　·支持RGBHV、RGBS、RGsB、RsGsBs、分量视频信号、S- 视频信号和复合视频信号

　·与双级和三级同步的 HDTV 分量视频兼容

　·前面板上配有LED 功率显示

　·结构紧凑的 1U、1/4 机架宽粗糙金属机箱

　·通用安装选项

　·提供外置型国际通用电源，产品编号为 # 70-055-01

示意图

面板图

 

MTP 15HD RS Series
 
Video 
   Gain  Unity
   Number/signal type  1 set of proprietary analog signals
   Connectors  1 female RJ-45
 
Video input and loop-through — transmitter (MTP T 15HD RS)
   Number/signal type  1 analog RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video
1 buffered RGBHV, RGBS, RGsB, RsGsBs local monitor loop through (includes ID bits)
   Connectors  2 female 15-pin HD
   Nominal level  1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
   Minimum/maximum levels  0.3 V to 1.45 Vp-p
   Impedance  75 ohms
   Horizontal frequency  15 kHz to 130 kHz
   Vertical frequency  30 Hz to 150 Hz
   Return loss  <-30 dB @ 5 MHz
   DC offset (max. allowable)  250 mV
 
Video output — receivers (MTP RL 15HD RS, MTP RL 15HD RS SEQ)
   Number/signal type  1 set of proprietary analog signals
1 analog RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video
   Connectors  1 female RJ-45
1 female 15-pin HD
   Nominal level  1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
   Minimum/maximum levels  0.3 V to 1.45 Vp-p
   Impedance  75 ohms
   Return loss  <-30 dB @ 5 MHz
   DC offset  <±20 mV with input at 0 offset
   Maximum resolution  1920x1200
       NOTE       Refer to the user's manual for the maximum distances recommended for specific resolutions.
 
Sync 
   Input type (transmitter)  RGBHV, RGBS, RGsB, RsGsBs
   Output type (receivers)  RGBHV, RGBS, RGsB, RsGsBs
   Standards  NTSC 3.58, NTSC 4.43, PAL, SECAM
   Input level (transmitter)  3.5 V to 5.5 Vp-p, unterminated
   Output level (receivers)  4.0 V to 5.0 Vp-p, unterminated
   Input impedance  510 ohms
   Output impedance  110 ohms
   Max. input voltage  5.5 Vp-p
   Polarity   
      Transmitter  Positive or negative (follows input polarity)
      Receivers  Positive or negative (switch selectable)
 
Control/remote — external device (pass-through, unidirectional or bidirectional)
   Serial control port input/output
      MTP T 15HD RS  RS-232 via (1) 3.5 mm, 3 pole captive screw connector
      Receivers  1 set of proprietary signals on a female RJ-45 jack
   Serial control port output/input
      MTP T 15HD RS  1 set of proprietary signals on a female RJ-45 jack
      Receivers  RS-232 via a 3.5 mm, 3 pole captive screw connector
    NOTE       The serial communications link of an MTP RL 15HD RS or MTP RL 15 HD RS SEQ is unidirectional only, transmitter to receiver, unless the receiver's directional jumper has been repositioned.  The jumper should be repositioned only when the receiver is the only one in the system.
   Baud rates  Up to 38400 bps at up to 600' (183 m) (Higher data rates and distances are possible. Performance will vary based on baud rate and cable length.)
   Protocol  Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none
    NOTE     　Protocol is mirrored between the transmitter and the receiver.
   Serial control pin configurations  Captive screw connectors: 1 = TX, 2 = RX, 3 = GND
 
General 
   Recommended cable type  CAT 5/5E/6 (shielded or unshielded)
   External power supply  100 VAC to 240 VAC, 50/60 Hz, external; to 12 VDC, 2 A, regulated
   Power input requirements  12 VDC, 0.5 A
   Temperature/humidity  Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
   Cooling  Convection, no vents
   Mounting
      Rack mount  Yes, with optional 1U, 9.5" deep rack shelf (RSU 129, #60-190-01 or RSB 129, #60-604-01); 1U, 6" deep rack shelf (RSU 126, #60-190-10 or RSB 126, #60-604-10); or VersaTools® 1U, 3.5" deep rack shelf (RSF 123, #60-190-20 or RSB 123, 60-604-20)
      Furniture mount  Yes, with optional Mini Under-Desk Mounting Kit, part #70-212-01 (MBU 123)
      Pole mount  Yes, with optional projector mounting kit, part #70-217-01 (PMK 100)
   Rack mount   
   Enclosure type  Metal
   Enclosure dimensions  1.7" H x 4.3" W x 3.0" D (1U high, quarter rack wide)
(4.3 cm H x 10.9 cm W x 7.6 cm D)
(Depth excludes connectors.)
   Product weight  0.4 lbs (0.2 kg)
   Shipping weight  2 lbs (1 kg)
   Vibration  ISTA 1A in carton (International Safe Transit Association)
   Regulatory compliance
      Safety  CE, C-tick, CUL, UL
      EMI/EMC  CE, C-tick, FCC Class A, ICES, VCCI
   MTBF  30,000 hours
   Warranty  3 years parts and labor
    NOTE     　All nominal levels are at ±10%.
    NOTE     　Specifications are subject to change without notice.

 

暂无相关附件!!!
暂无相关下载!!!